Configuring Domain Name Policies¶

The microservice gateway provides the domain name level policy configuration capability. After a domain name level policy is configured, you do not need to configure policies for multiple apis under the same domain name. Currently, four domain-level policies are supported: cross-domain、global rate limit、local traffic limiting、black/white List.

You can configure domain name policies in either of the following ways:

• For details about how to set policies when creating domain names, see Add Domain.
• After the domain name is created, run the Change Domain command to adjust the domain name.

The cross-domain and local traffic limiting policies are described as follows:

Local current limiting¶

After you configure local traffic limiting for a domain name, the configuration is automatically applied to all apis that use the domain name.

For details about configuring local traffic limiting, see Local Rate Limit.

cross-domain¶

Note the following when filling in the configuration:

• Enable credentials: After this is enabled, cross-domain requests need to be checked for credentials. After the check is passed, the cross-domain request can be processed.
• Allowed request method: Select the HTTP request mode. See the official W3C document Name Method Definitions for detailed instructions on the various request methods.
• Allowable request sources: Limit multiple specific request sources, usually using IP.
• Pre-check duration: indicates the duration of checking credentials and request methods before processing cross-domain requests. The unit of time is seconds, minutes, and hours.
• Allowable request headers: Qualifies specific HTTP request header keywords. After the keyword is added, the corresponding keyword must be added to the request header to access the target service.
• Exposed request header: Controls the exposed request header keyword. Multiple values can be configured.

Comments